PN012 – PIN manager
December 23, 2015
JL002 – Key programming functionality
December 23, 2015
Show all

PN013 – BSI, Instrument cluster data manager

1,400.00


SKU: pn013. Category: .
Description

With this special function you can read and and calibrate the mileage stored in the BSI module and remove the synchronization with the instrument cluster (i.e. The modification is performed in the BSI exclusively and after a complete ignition cycle the mileage is not restored to the original value). In the cases where the sync removal does not apply it can calibrate the mileage in the cluster exclusively. Supported models are all CAN and UDS protocol models which includes almost all models produced after 2004. This function can be used independently.

 

Supported Vehicles for Calibration: 

Peugeot Citroën
1007
207
307 2005+
208 2012+
2008 2013+
301 2012+
Citroën Berlingo 2008+
308
3008
508
5008
407
607 2006+
807 2006+
Expert II
Partner 2008+
C-Elysee 2012+
C2
C3 2006+
C3 II
DS3
C4
C4 Picasso
C4 II
DS4
C5 2004+
C5 II 2007+
DS5
C6
C8 2007+
Jumpy II
Lancia Phedra 2008+

BSI Exchange – allows you to read the whole content of the one BSI (JCI or Valeo CAN) and transfer it to another one. It is very important to use the same hardware type for the replacement BSI. The Valeo BSIs are two types – the old one is thick, while the new one is thin, so they can’t be mistaken. To use this special function you need to have PN012 + PN013 special fucntions. The UDS BSI modules are supported via read/write EEPROM and flash.

 

 

New AVDI Interface or activate AMS is required to purchase this special functions.

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “PN013 – BSI, Instrument cluster data manager”

Your email address will not be published. Required fields are marked *